Hinge Adjustment and Replacement in Macon, GA
Door hinge adjustment and replacement in Macon, GA. Fix squeaks, sags, and misaligned doors fast.
A door that sags, scrapes the floor, or won't latch is almost always a hinge problem. We adjust, tighten, and replace door hinges throughout Macon, GA — fixing issues that make doors frustrating to use and leaving them operating smoothly without replacing the entire door unit.
In Macon's older homes, loose hinges are especially common. Wood screws strip out over time as the wood compresses under years of repeated door swings. We fix this properly: longer screws into solid wood, or wood glue and toothpick fills on stripped holes before reinstalling, depending on the condition. The result is a door that swings cleanly and latches on the first try.
We also replace hinges entirely when they're bent, corroded, or when you're upgrading to soft-close concealed hinges on cabinet doors. This is one of the higher-impact-per-dollar upgrades you can make in a kitchen — quiet, controlled door movement on every cabinet.
What's Included
- Hinge tightening and screw replacement with longer fasteners
- Stripped screw hole repair
- Hinge replacement (matching style or upgraded)
- Door alignment check after adjustment
- Cabinet soft-close hinge installation
Why Choose Handyman Macon GA for Hinge Adjustment and Replacement?
The difference between a hinge fix that lasts and one that fails again in six months is whether someone addressed the actual cause. Stripped screw holes — the most common hinge problem in Macon's older homes — need to be properly filled and redrilled or replaced with longer fasteners that reach solid wood. Tightening the original screw into a stripped hole just delays the next service call. We fix it correctly the first time. For cabinet hinges, we upgrade to soft-close hardware while we have the doors off — a minor cost that eliminates slamming in kitchens and bathrooms and makes the whole cabinet feel new.
How Hinge Adjustment and Replacement Works
- Cause diagnosis — We identify whether the problem is stripped screw holes, a worn hinge pin, or a hinge that's shifted out of alignment. Each requires a different fix — we don't treat all squeaks and sags the same way.
- Stripped hole repair — Stripped holes are filled with wood filler and given proper cure time before redrilling. Tightening a screw into stripped wood just delays the next service call by a few months.
- Hardware installation — Replacement hinges are mortised flush with the jamb face and fastened with screws long enough to reach solid wood beyond the doorstop. Soft-close hinges are set to correct closing tension.
- Swing and latch test — Door is cycled through a full swing and confirmed to latch without lifting or forcing. Soft-close speed is adjusted before we leave.
Hinge Adjustment Cost in Macon, GA
A single door hinge adjustment or tightening typically runs $55–$95. Full hinge replacement on a door (all three hinges) is generally $95–$175 including hardware. For cabinet doors, soft-close hinge replacement is $10–$18 per door when done as a batch on a full kitchen — most kitchens complete in a single visit.
We carry common hinge styles and soft-close hardware on the truck. Call (877) 368-1249 for a free estimate.
Related Services
Frequently Asked Questions
Have a question? Call us at (877) 368-1249 and we'll answer it directly.
- Yes, most of the time. A sagging door is usually a hinge issue. We adjust the hinge position or shim it to raise the door back into alignment.
- A single door typically takes 20–40 minutes. Multiple doors in a batch take less time per door.